If I can have somebody point me in the right direction.
I have a 2 ip cameras, hooked into a network switch. The I have two decoders that hooked into the switch. Now I have VGA monitors on the other side of the decoder.
So I want to write a program that I can press a button click event. And camera 1 will send the video siginal to monitor 1 or 2, depending on what button I click.
How would I go about doing this? I was thinking maybe I control this throught the network switch via rs232. Can I actually call to a jack on a ntwork switch with a AT command?
Or can I send a command direct to the camere or decoder, which also has an IP address.
Where would I start looking for stuff on this?
TIA!!
Rudy
I have a 2 ip cameras, hooked into a network switch. The I have two decoders that hooked into the switch. Now I have VGA monitors on the other side of the decoder.
So I want to write a program that I can press a button click event. And camera 1 will send the video siginal to monitor 1 or 2, depending on what button I click.
How would I go about doing this? I was thinking maybe I control this throught the network switch via rs232. Can I actually call to a jack on a ntwork switch with a AT command?
Or can I send a command direct to the camere or decoder, which also has an IP address.
Where would I start looking for stuff on this?
TIA!!
Rudy